Intel TC 64 LX CF, TC 32 LX CF manual Installation

Page 4

Installation

1.Disconnect the power from the PC and open the PC case

2.Install the TC-card in any spare expansion card mounting slot.

3.Locate the hard-drive and disconnect the IDE hard drive ribbon cable from the hard drive and connect it to the IDE hard drive connector on the TC-card.

4.Connect a 3.5" floppy-drive-style power plug to the Power connector.

5.Ensure the TC-card is jumpered for Master (M).

6.Close the case and power on the PC

7.The PC should now behave like an IGEL Clever Client. See the IGEL Clever Client user's guide for more information.

Additional installation notes and photographs are provided on the next page

Power Connector

Master/Slave Jumper

40 pin IDE Connector

44 pin laptop compatible IDE header (not normally used)

Figure 1

Principal features of the IGEL TC-card

3

Image 4
Contents Igel TC-Card Installation Guide TC 32 LX CF and TC 64 LX CF Page Introduction Installation Mounting the TC-Card TC-card must be set to be master Power Connector Cirrus Logic Alpine, Laguna Sundance Alta Igel Technology GmbH