Intel TC 64 LX CF, TC 32 LX CF manual TC-card must be set to be master

Page 6

Connecting the Hard Drive Cable

 

The TC-card must be set to be master

 

(figure 3) and be connected to the primary

 

IDE channel. The 40 pin hard drive cable

 

connector usually has a “key” on one side

 

(figure 4). Ensure this mates with the

 

notch in the 40 pin socket on the TC-Card.

 

If the cable has no key ensure the red

 

stripe on the cable is at the same end as

 

pin 1 on the TC card socket. (figure 5).

 

Any other device on the primary channel

 

should be set to slave (rather than using

 

“cable select”). Note: Flashing keyboard

 

lights indicates a problem and most

 

often this is because the TC card is not

 

primary master.

Figure 5

Figure 4

Figure 3

5

Image 6
Contents Igel TC-Card Installation Guide TC 32 LX CF and TC 64 LX CF Page Introduction Installation Mounting the TC-Card TC-card must be set to be master Power Connector Cirrus Logic Alpine, Laguna Sundance Alta Igel Technology GmbH