Intel MB890 user manual DDR Module, Installing the Memory, Lock

INSTALLATIONS

Installing the Memory

The MB890 board supports one DDR memory sockets for a maximum total memory of 1GB in DDR memory type. The memory module capacities supported are 128MB, 256MB, 512MB and 1GB. The following table lists the supported DDR DIMM configurations. Intel® 855GME supports configurations defined in the JEDEC DDR DIMM specification only. Non-JEDEC standard DIMMs such as double-sided x16 DDR SDRAM DIMMs are not supported.

Installing and Removing Memory Modules

To install the DDR modules, locate the memory slot on the board and perform the following steps:

1.Hold the DDR module so that the key of the DDR module align with those on the memory slot.

2.Gently push the DDR module in an upright position until the clips of the slot close to hold the DDR module in place when the DDR module touches the bottom of the slot.

3.To remove the DDR module, press the clips with both hands.

Lock DDR Module Lock

Lock Lock

MB890 User’s Manual 7