Intel D845PEMY manual Bios Error Messages, Error Message Explanation

Page 52

Intel Desktop Board D845PEMY Product Guide

BIOS Error Messages

When a recoverable error occurs during the POST, the BIOS displays an error message describing the problem.

Table 14. BIOS Error Messages

Error Message

Explanation

 

 

GA20 Error

An error occurred with Gate-A20 when switching to protected mode

 

during the memory test.

 

 

Pri Master HDD Error

Could not read sector from corresponding drive.

Pri Slave HDD Error

 

Sec Master HDD Error

 

Sec Slave HDD Error

 

 

 

Pri Master Drive - ATAPI Incompatible

Corresponding drive is not an ATAPI device. Run Setup to make

Pri Slave Drive - ATAPI Incompatible

sure device is selected correctly.

Sec Master Drive - ATAPI Incompatible

 

Sec Slave Drive - ATAPI Incompatible

 

 

 

A: Drive Error

No response from the diskette drive.

B: Drive Error

 

 

 

CMOS Battery Low

The battery may be losing power. Replace the battery soon.

 

 

CMOS Display Type Wrong

The display type is different than what has been stored in CMOS.

 

Check Setup to make sure type is correct.

 

 

CMOS Checksum Bad

The CMOS checksum is incorrect. CMOS memory may have been

 

corrupted. Run Setup to reset values.

 

 

CMOS Settings Wrong

CMOS values are not the same as the last boot. These values

 

have either been corrupted or the battery has failed.

 

 

CMOS Date/Time Not Set

The time and/or date values stored in CMOS are invalid. Run

 

Setup to set correct values.

 

 

DMA Error

Error during read/write test of DMA controller.

 

 

FDC Failure

Error occurred trying to access diskette drive controller.

 

 

HDC Failure

Error occurred trying to access hard disk controller.

 

 

Checking NVRAM

NVRAM is being checked to see if it is valid.

 

 

Update OK!

NVRAM was invalid and has been updated.

 

 

Updated Failed

NVRAM was invalid but was unable to be updated.

 

 

Keyboard Is Locked

The system keyboard lock is engaged. The system must be

 

unlocked to continue to boot.

 

 

Keyboard Error

Error in the keyboard connection. Make sure keyboard is

 

connected properly.

 

 

KB/Interface Error

Keyboard interface test failed.

 

 

 

continued

52

Image 52
Contents Intel Desktop Board D845PEMY Product Guide Revision History Revision Revision History DateFCC Declaration of Conformity Canadian Department of Communications Compliance StatementPreface Intended AudienceInformation Layout ConventionsBox Contents TerminologyContents Bios Contents TablesViii Desktop Board Features Feature SummarySupported Operating Systems Desktop Board Features Desktop Board ComponentsBios Item DescriptionProcessor Processor SupportMain Memory Memory SupportIntel D845PE Chipset Audio SubsystemRJ-45 LAN Connector LEDs LAN SubsystemEnhanced IDE Interface Expansion SlotsIDE Auto Configuration PCI Auto ConfigurationSecurity Passwords Power Management Features Power ConnectorsChassis Intrusion Fan HeadersSpeaker BatteryReal-Time Clock Intel Desktop Board D845PEMY Product Guide Installing and Replacing Desktop Board Components Before You BeginInstallation Instructions Installation PrecautionsEnsure Electromagnetic Compatibility EMC Compliance Prevent Power Supply Overload Place Battery MarkingInstalling and Replacing Desktop Board Components Chassis and Component CertificationsInstalling the I/O Shield Use Only for Intended ApplicationsInstalling and Removing the Desktop Board Desktop Board Mounting Screw HolesInstalling a Processor Installing and Removing a ProcessorInstalling the Processor Fan Heatsink Connecting the Processor Fan Heatsink Cable Removing a ProcessorInstalling an AGP Card Installing and Removing an AGP CardRemoving the AGP Card Installing and Removing Dimms Installing DIMMsConnecting the IDE Cable Removing DIMMsConnecting the IDE Cable Connecting Internal Headers Internal HeadersFront Panel Audio Header Signal Names J8A1 Installing a Front Panel Audio SolutionPin Signal Name Connecting the Front Panel Header Installing a USB SolutionFront Panel Header USB HeaderConnecting Hardware Control and Power Cables Location of Hardware Control Headers and Power ConnectorsConnecting Power Cables Connecting FansConnecting the Chassis Intrusion Cable Locating the Add-in Card and Peripheral Interface Connectors Jumper Settings for the Bios Setup Program Modes Setting the Bios Configuration Jumper BlockJumper Setting Mode Description Clearing Passwords Back Panel Connectors Back Panel ConnectorsReplacing the Battery PrécautionPrecaución Awas Removing the Battery from the Desktop Board Using the Bios Setup Program Updating the BiosUpdating the Bios with the Intel Iflash Bios Update Utility Obtaining the Bios Update FileUpdating the Bios Recovering the BiosBios Intel Desktop Board D845PEMY Product Guide Desktop Board Resources Memory MapDMA Channels System Memory MapInterrupts InterruptsError Messages and Indicators Bios Beep CodesBeep Codes Number of Beeps DescriptionBios Error Messages Bios Error MessagesError Message Explanation Error Messages and Indicators Nvram / Cmos / PasswordIntel Desktop Board D845PEMY Product Guide Safety Regulations Safety RegulationsRegulatory Compliance European Union Declaration of Conformity StatementDisposal Considerations Product Ecology StatementsRecycling Considerations EMC Regulations EMC RegulationsRegulatory Compliance Product Certification Markings Product Certification Markings Board LevelDescription Mark