English
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show Open and the Length fields show 0.0m, as shown in the figure above.
When LAN Cable Is Functioning Normally...
If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub, the following message will appear:
Start detecting at Port.....
Link Detected
Cable Length= 30m
Link Detected | Displays transmission speed |
Cable Length | Displays the approximate length of the attached LAN cable |
Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in
When a Cable Problem Occurs...
If a cable problem occurs on a specified pair of wires, the Status field will show Short and the length shown will be the approximate distance to the fault or short.
Example:
Explanation: A fault or short might occur at about 1.6m on Pair
Note: Pair
OnBoard LAN Boot ROM
This function decide whether to invoke the boot ROM of the onboard LAN chip.
Enabled | Enable this function. |
Disabled | Disable this function. (Default value) |
Onboard Serial Port 1
Disabled | Disable onboard Serial port 1. |
3F8/IRQ4 | Enable onboard Serial port 1 and address is 3F8/IRQ4. (Default value) |
2F8/IRQ3 | Enable onboard Serial port 1 and address is 2F8/IRQ3. |
3E8/IRQ4 | Enable onboard Serial port 1 and address is 3E8/IRQ4. |
2E8/IRQ3 | Enable onboard Serial port 1 and address is 2E8/IRQ3. |
Auto | BIOS will automatically setup the port 1 address. |
Onboard Parallel Port
Disabled | Disable onboard LPT port. |
378/IRQ7 | Enable onboard LPT port and address is 378/IRQ7. (Default value) |
278/IRQ5 | Enable onboard LPT port and address is 278/IRQ5. |
3BC/IRQ7 | Enable onboard LPT port and address is 3BC/IRQ7. |
|
|
- 38 - |