Integrated Peripherals |
|
|
| |||
|
|
|
| |||
|
| CMOS Setup |
| |||
|
|
| Integrated Peripherals |
|
| |
| [Enabled] |
|
| Item Help | ||
| [Auto] |
| Menu Level` | |||
x | PATA IDE Set to | Ch.0 Master/Slave |
|
| ||
| SATA Port 0/2 Set to | Ch.2 Master/Slave |
|
| ||
| SATA Port 1/3 Set to | Ch.3 Master/Slave |
|
| ||
| USB Controller |
| [Enabled] |
|
|
|
| USB 2.0 Controller | [Enabled] |
|
|
| |
| USB Keyboard Support | [Disabled] |
|
|
| |
| USB Mouse Support | [Disabled] |
|
|
| |
| Legacy USB storage detect | [Enabled] |
|
|
| |
| Azalia Codec |
| [Auto] |
|
|
|
| Onboard H/W LAN | [Enabled] |
|
|
| |
` | SMART LAN |
| [Press Enter] |
|
| |
| Onboard LAN Boot ROM | [Disabled] |
|
|
| |
| Onboard Serial Port 1 | [3F8/IRQ4] |
|
| ||
| Onboard Parallel Port | [378/IRQ7] |
|
| ||
| Parallel Port Mode | [SPP] |
|
|
| |
x ECP Mode Use DMA | 3 |
|
|
| ||
KLJI: Move | Enter: Select | F10: Save | ESC: Exit | F1: General Help | ||
| F5: Previous Values | F6: |
| F7: Optimized Defaults | ||
|
|
|
|
|
|
|
On-Chip Primary PCI IDE
Enables or disables the integrated IDE controller. (Default: Enabled)
On-Chip SATA Mode
Configures the integrated SATA controller.
Disabled | Disables the integrated SATA controller. |
Auto | Lets BIOS set SATA devices to Combined or Enhanced mode. |
| If your onboard SATA controller is automatically configured to Combined |
| mode, you can manually |
| (Default) |
Combined | Sets all SATA devices to operate in PATA mode. Combined allows a |
| maximum of 4 ATA devices to be used simultaneously: two PATA devices |
| plus two SATA devices. |
Enhanced | Sets all SATA devices to operate in SATA mode. |
Sets all SATA devices to operate in PATA mode and disables the integrated | |
| IDE controller. |
PATA IDE Set to
This item is configurable only if the
Ch.0 Master/Slave Sets the IDE channels to Ch. 0 Master/Slave. (Default)
Ch.1 Master/Slave Sets the IDE channels to Ch. 1 Master/Slave.
Disabled Disables the integrated IDE controller when
SATA Port 0/2 Set to
This value is dependent on the
When PATA IDE Set to is configured to Ch. 1 Master/Slave, this option will be automatically set to Ch. 0 Master/Slave.
- 37 - | BIOS Setup |