Intel GA-8N775 user manual Troubleshooting

Page 84

English

4-2 Troubleshooting

Below is a collection of general asked questions. To check general asked questions based on a specific motherboard model, please log on to www.gigabyte.com.tw

Question 1: I cannot see some options that were included in previous BIOS after updating BIOS. Why?

Answer: Some advanced options are hidden in new BIOS version. Please press Ctrl and F1 keys after entering BIOS menu and you will be able to see these options.

Questions 2: Why is the light of my keyboard/optical mouse still on after computer shuts down?

Answer: In some boards, a small amount of electricity is kept on standby after computer shuts down and that's why the light is still on.

Question 3: How do I clear CMOS?

Answer: If your board has a Clear CMOS jumper, please refer to the Clear CMOS steps in the manual. If your board doesn't have such jumper, you can take off the on-board battery to leak voltage to clear CMOS. Please refer to the steps below:

Steps:

1.Turn off power.

2.Disconnect the power cord from MB.

3.Take out the battery gently and put it aside for about 10 minutes (Or you can use a metal object to connect the positive and negative pins in the battery holder to makethem short for one minute).

4.Re-insert the battery to the battery holder.

5.Connect power cord to MB again and turn on power.

6.Press Del to enter BIOS and load Fail-Safe Defaults(or load Optimized Defaults).

7.Save changes and reboot the system.

Question 4: Why do I still get a weak sound after turning up the speaker to the maximum volume?

Answer: Please make sure the speaker you are using is equipped with an internal amplifier. If not, please change another speaker with power/amplifier and try again later.

Question 5: Sometimes I hear different continuous beeps from computer after system boots up. What do these beeps usually stand for?

Answer: The beep codes below may help you identify the possible computer problems. However, they are only for reference purposes. The situations might differ from case to case.

AMI BIOS Beep Codes

*Computer gives 1 short beep when system boots successfully. *Except for beep code 8, these codes are always fatal.

1 beep Refresh failure

2 beeps Parity error

3 beeps Base 64K memory failure

4 beeps Timer not operational

5 beeps Processor error

6 beeps 8042 - gate A20 failure

7 beeps Processor exception interrupt error

8 beeps Display memory read/write failure

9 beeps ROM checksum error

10 beeps CMOS shutdown register read/write error

11 beeps Cache memory bad

GA-8N775 Motherboard

- 84 -

AWARD BIOS Beep Codes

1 short: System boots successfully

2 short: CMOS setting error

1 long 1 short: DRAM or M/B error

1 long 2 short: Monitor or display card error

1 long 3 short: Keyboard error

1 long 9 short: BIOS ROM error

Continuous long beeps: DRAM error

Continuous short beeps: Power error

Image 84
Contents GA-8N775 Motherboard Copyright Product Manual ClassificationTable of Contents Drivers Installation GA-8N775 Motherboard Layout GA-8N775Block Diagram Page Considerations Prior to Installation Installation NoticesInstances of Non-Warranty Preparing Your ComputerFeature Summary CPU4Mbit flash ROM Installation of the CPU and Heatsink Installation of the CPUInstallation of the Heatsink Installation of Memory Dual Channel Memory Configuration Installation of Expansion Cards I/O Back Panel Introduction Connectors Introduction Side Speaker OutATX12V / ATX Power Connector Cpufan / Sysfan Cooler Fan Power Connector FDD Floppy ConnectorIDE1 / IDE2 IDE Connector Pwrled Fpanel Front Panel Jumper Faudio Front Audio Panel Connector Cdin CDSpdifi Spdif In Connector USB1 / FUSB2 / FUSB3 Front USB ConnectorClrcmos Clear Cmos CI Chassis Intrusion, Case OpenRfid English Status Page Setup Menu / Option Page Setup Menu Main MenuMain Menu For example Bios Ver. E5 F12 For Boot Menu„ Standard Cmos Features „ Advanced Bios Features„ Power Management Setup „ PnP/PCI ConfigurationStandard Cmos Features DateTime IDE Channel 0 Master/Slave IDE Channel 1 Master/SlaveFloppy 3 Mode Support for Japan Area Drive a / Drive BHalt on MemoryAdvanced Bios Features Hard Disk Boot PriorityFirst / Second / Third Boot Device Boot Up Floppy SeekPassword Check CPU Hyper-ThreadingLimit Cpuid Max. to No-Execute Memory Protect NoteIntegrated Peripherals SPPIDE Secndry Slave RAID Sataii 1 Primary RAIDSataii 1 Secondary RAID Sataii 2 Primary RAIDOnboard LAN Boot ROM Parallel Port ModeOn-Chip USB USB Keyboard SupportPower Management Setup Power-On by AlarmPME Event Wake Up Modem Ring OnPower On by Mouse Power On by KeyboardKB Power on Password AC Back FunctionPnP/PCI Configurations INTPC Health Status CPU Smart FAN Mode CPU Smart FAN ControlFSB Turbo Mode MB Intelligent TweakerM.I.TM. Note CPU Clock Ratio NoteSystem Clock Mode New FSB Speed QDRCurrent FSB Speed QDR Target FSB Speed QDRLoad Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password Save & Exit Setup Exit Without SavingDrivers Installation Install Chipset DriversSoftware Application Software InformationHardware Information Contact UsEnglish Unique Software Utilities EasyTune 5 Introduction User Interface OverviewXpress Recovery2 Introduction How to use the Xpress Recovery2System requirements Main Screen of Xpress Recovery2 PrecautionsLimitations Flash Bios Method Introduction Method 1 Q-FlashTMUtilityBefore You Begin Exploring the Q-FlashTM / Dual Bios utility screen Task menu for Dual Bios utilityEntering the Q-FlashTMutility Task menu for Q-Flash utilityUsing the Q-FlashTMutility StepsYou can repeat to Part Two Exploring the Q-FlashTMutility screen EnglishCongratulation!! You have updated Bios successfully Bios file becomes F4 after updatingMethod 2 @BIOSTM Utility Methods and stepsEnglish Configuring Sata Hard Drives To configure Sata hard drives, follow the steps belowSPP GA-8N775 Motherboard Step Save and exit Bios Setup Configuring RAID set in RAID Bios YES Nvidia Cd bootdrv Menu Making a Sata Driver DiskInstalling Sata controller driver during OS installation NForce Storage Controller Enter= Continue R=Repair F3=Exit Configuring a bootable RAID array with Microsoft Windows SolutionsYES Appendix Introduction of audio connectors Stereo Speakers Connection and Settings5 2- / 4- / 6- / 8- Channel Audio Function Introduction Channel Audio Setup English Step Troubleshooting English English Contact Us Taiwan HeadquartersChina Shanghai

GA-8N775 specifications

The Intel GA-8N775 is a motherboard that serves as an excellent platform for enthusiasts and gamers looking to build a high-performance PC. Designed to support Intel processors, this motherboard is specifically engineered to enhance performance through a range of innovative features and technologies.

One of the standout characteristics of the GA-8N775 is its support for the Intel LGA 775 socket, accommodating a variety of Pentium 4, Pentium D, and Celeron series processors. This flexibility allows users to choose from a spectrum of CPUs, facilitating upgrades and customization according to their needs.

The GA-8N775 is built on the NVIDIA nForce4 chipset, recognized for its robust performance capabilities. This chipset enhances the overall system stability and processing power, crucial for demanding applications and intensive gaming sessions. The motherboard supports dual-channel DDR2 memory, offering increased bandwidth and improved system performance. With multiple memory slots available, users can expand their memory to meet the requirements of modern applications, playing a vital role in multitasking and overall system responsiveness.

Another notable feature is the integrated NVIDIA graphics support, which allows users to enjoy decent graphics performance without the need for a dedicated GPU. However, the motherboard also includes PCI Express x16 slots, providing the flexibility for users who wish to install high-end graphics cards for superior gaming and graphical capabilities.

For storage, the GA-8N775 supports a variety of SATA connections, allowing users to connect multiple hard drives and SSDs for increased storage capacity and faster data transfer speeds. The board also features RAID support, giving users options for data redundancy and performance optimization.

In terms of connectivity, the motherboard is equipped with several USB ports, ensuring compatibility with various peripherals. Additionally, integrated audio capabilities provide satisfactory sound quality for most users, making it suitable for both gaming and multimedia applications.

The GA-8N775 is designed with upgradeability and durability in mind. Its robust PCB and numerous expansion slots ensure longevity and adaptability as technology progresses. Overall, the Intel GA-8N775 motherboard is an ideal choice for building a versatile and powerful computing system, suitable for a wide range of users, from gamers to professionals in need of reliable performance.