Intel 8I845PE-RZ-C user manual Introduction, Features Summary

Page 5

Chapter 1 Introduction

Features Summary

CPU

—

Socket 478 for Intel® Pentium ® 4 (Northwood, Prescott (Note 1)) with HT

 

 

Technology

 

—

Intel® Pentium ® 4 800(Note 2)/533/400M Hz FSB

 

— 2nd cache depends on CPU

Chipset

— North Bridge: Intel® 82845PE M CH

 

—

South Bridge: Intel® 82801 (ICH4)

Memory

— 3

184- pin DDR DIMM sockets, supports up to 2GB DRAM (Max)

 

—

Supports DDR400(Note 3)/DDR333/DDR266 DIMM

 

— Supports only 2 .5V DDR SDRAM

Slots

—

1

AGP slot 4X (1.5V) device support

 

—

5

PCI slots support 33M Hz & PCI 2.2 compliant

On- Board IDE

— 2

IDE controller provide IDE HDD/CD-ROM(IDE1, IDE2) with PIO, Bus

 

 

Master (Ultra DM A33/ATA66/ATA100) operation modes

—Can connect up to 4 IDE devices

On -Board Floppy — 1 Floppy port supports 2 FDD with 360K, 720K,1.2M, 1.44M and 2.88M bytes

On-Board Peripherals — 1 Parallel port supports Norm al/EPP/ECP mode

—2 Serial port (COMA/COM B)

—6 USB 2.0/1 .1 ports (2 x Rear, 4 x Front by cable)

—1 Front Audio connector

—1 PS/2 Keyboard

—1 PS/2 Mouse

On -Board LAN * — Builit- in RTL8100C chipset *

—1 RJ45 port *

On-Board Sound — CM edia 9761A CODEC

—Support 2/4/6 channel

—Line Out / Line In / Mic In

—SPDIF Out /SPDIF In

—CD In/ AUX_IN/ Game Port

BIOS— Licensed AWARD BIOS

—Supports Q- Flash™

I/O Control

—

ITE8712

Hardware M onitor

—

CPU/System Fan Revolution detect

 

— CPU/System Fan Fail Warning

 

—

CPU Overheat Warning

 

—

System Voltage Detect

Additional Features

—

Supports @BIOS™

 

—

Supports EasyTune 4™

Overclocking

—

Over Voltage (DDR/AGP/CPU) by BIOS

—Over Clock (DDR/AGP/CPU) by BIOS

Form Factor— ATX size form factor, 29 .5cm x 21cm

(Note 1) Prescott processors with up to 533MHzFSB are supported.

(Note 2) ANorthwood processor with 800MHzFSB can be supported through overclocking in BIOS.

(Note 3) When 800MHzFSB is selected as processor frequency, memorywill automaticallyadjust to DDR400. "*" For 8I845PE-RZ only.

English

- 5 -

Introduction

Image 5
Contents 8I845PE-RZ / 8I845PE-RZ-C Feb.20 Preparing Your Computer Installing the motherboard to the chassisTable of Contents Introduction Features Summary8I845PE-RZ 8I845PE-RZ Series Motherboard LayoutEnglish Block DiagramStep Hardware Installation ProcessInstall the Central Processing Unit CPU CPU Installation DDR Install Memory ModulesInstall I/O Peripherals Cables Install AGP CardMIC In jack CdinLAN port ~ USB portCpufan CPU Fan Connector ATX12V +12V Power ConnectorAtxatx Power FDD Floppy Connector Sysfan System Fan ConnectorIDE1 / IDE2 IDE1 / IDE2 Connector Fpanel 2 x 10 pins Connector Cdin CD In Connector Faudio Front Audio ConnectorSurcen Surround Center Connector Spdifio Spdif In/Out Connector Auxin AUX In ConnectorClrcmos Clear Cmos FUSB1 / FUSB2 Front USB ConnectorMain Menu Main Menu For example Bios Ver. FacStatus Page Setup Menu / Option Page Setup Menu PowerManagement Setup Advanced Bios FeaturesPnP/PCI Configuration Load Fail-Safe DefaultsDate Standard Cmos FeaturesTime IDE Primary Master, Slave / IDE Secondary Master, SlaveDrive a / Drive B Floppy 3 Mode Support for Japan AreaHalt on MemoryFirst / Second / Third Boot Device Advanced Bios FeaturesBoot Up Floppy Seek PasswordCheckIntegrated Peripherals Parallel Port Mode Onboard H/W LAN Boot ROMUSB Controller USB Keyboard SupportPower Management Setup Power On By Mouse Resume by AlarmPower On By Keyboard KB Power on PasswordPCI 1/PCI 5 IRQ Assignment PnP/PCI ConfigurationsPCI 2 IRQ Assignment PCI 3 IRQ AssignmentPC Health Status CPU Clock Ratio Frequency/Voltage ControlCPU Host Clock Control CPU Host Frequency MHzHost/DRAM Clock Ratio Top PerformanceMemory Frequency Mhz PCI/AGP FrequencyMhzLoad Optimized Defaults Load Fail-Safe DefaultsConfigurationsEnter Password Set Supervisor/User PasswordExit Without Saving Save & Exit SetupPictures below are shown in Windows XP Install DriversItem Description Memo English English Contact US