Diagnostic Error Code | FRU/Action | |
|
|
|
1. | Press F3 to review the log file | |
| 2. | |
|
|
|
1. | Make sure the component that is called out is | |
|
| connected and/or enabled. See Chapter 6 "Using |
|
| the Setup Utility" on page 39 |
| 2. | |
| 3. | Replace the component that is called out in warning |
|
| statement |
| 4. | Replace the component under test |
|
|
|
1. | If a component is called out, make sure it is | |
|
| connected and/or enabled. See Chapter 6 "Using |
|
| the Setup Utility" on page 39 |
| 2. | Flash the system and |
|
| procedures" on page 467 |
| 3. | Go to "Undetermined problems" on page 65 |
|
|
|
1. | Go to "Undetermined problems" on page 65 | |
| 2. | Flash the system and |
|
| procedures" on page 467 |
| 3. | Replace component under function test |
|
| |
No action | ||
|
|
|
1. | Riser card, if installed | |
| 2. | System board |
|
|
|
1. | PCI card | |
| 2. | Information only |
|
|
|
1. | Press F3 to review the log file | |
| 2. | |
|
|
|
1. | Make sure the component that is called out is | |
|
| connected and/or enabled. See Chapter 6 "Using |
|
| the Setup Utility" on page 39 |
| 2. | |
| 3. | Replace the component that is called out in warning |
|
| statement |
| 4. | Replace the component under test |
|
|
|
1. | If a component is called out, make sure it is | |
|
| connected and/or enabled. See Chapter 6 "Using |
|
| the Setup Utility" on page 39 |
| 2. | Flash the system and |
|
| procedures" on page 467 |
| 3. | Go to "Undetermined problems" on page 65 |
|
|
|
1. | Go to "Undetermined problems" on page 65 | |
| 2. | Flash the system and |
|
| procedures" on page 467 |
| 3. | Replace component under function test |
|
|
|