![](/images/new-backgrounds/1102778/102778157x1.webp)
This section provides information on how to remove and replace the power supply. To remove or replace the power supply, do the following:
1.Remove the computer cover. See "Removing the cover" on page 68. Note: For this procedure, it helps to lay the computer on its side.
2.Disconnect the power supply cables from the system board and from all drives.
3.Remove the four screws that secure the power supply at the rear of the chassis.
4.Lift the power supply out of the chassis.
5.If the power supply has a
•If the voltage supply range in your local country or region is
•If the voltage supply range in your local country or region is
6.Install the new power supply into the chassis so that the screw holes in the power supply align with those in the chassis.
7.Install the four screws to secure the power supply. Note: Use only the screws provided by Lenovo.
8.Reconnect the power supply connectors to the system board. See "Locating parts on the system board" on page 71.
9.Reconnect a power supply connector to each of the drives.
10.Go to "Completing the FRU replacement" on page 91.
Replacing the system board
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five minutes to let the computer cool before opening the computer cover.
Chapter 8 Replacing FRUs (Types 7061, 7090, 9353, 9421, 9485, 9623, 9625, 9705, 9786, 9795, 9935, 9946, 9953) 73