Lenovo 8458, 8455, 8453, 8454, 8459, 8460, 8457, 8456 manual User Guide

Page 46

To clean a mouse with a ball:

1.Turn off your computer.

2.Turn the mouse over, with the top side down, and look carefully at the bottom. Twist the retainer ring1to the unlocked position to remove the ball.

3.Place your hand over the retainer ring and ball2, and then turn the mouse over, top side up, so that the retainer ring and ball fall out into your hand.

4.Wash the ball in warm, soapy water then dry it with a clean cloth. Blow air carefully into the ball cage4to dislodge dust and lint.

5.Look for a build up of dirt on the plastic rollers3inside the ball cage. This build up usually appears as a stripe running across the middle of the rollers.

6.If the rollers are dirty, clean them by using a cotton swab soaked in isopropyl (rubbing) alcohol. Turn the rollers with your finger and continue swabbing them until all the dirt is removed. Be sure the rollers are still centered in their channels after you clean them.

7.Remove any fibers from the swab that might be remaining on the rollers.

8.Replace the ball and the retainer ring.

9.Turn your computer back on.

30User Guide

Image 46

Contents User Guide Lenovo 3000 J Series Page Lenovo 3000 J Series Page Contents Iv User Guide Important safety information Conditions that require immediate actionGeneral safety guidelines ServicePower cords and power adapters Plugs and outlets Extension cords and related devicesBatteries CD and DVD drive safety Heat and product ventilationLithium battery notice Additional safety informationTo connect To disconnect Modem safety information Laser compliance statementPower supply statement Overview Information resourcesXiv User Guide Installing options FeaturesConnectivity Operating systems, preinstalled varies by model Available options Weight SpecificationsDimensions EnvironmentTools required Supported operating positionsHandling static-sensitive devices Installing external options Locating connectors on the rear of your computer Connector Description Obtaining device driversRemoving the cover Locating components Accessing system board components Identifying parts on the system board User Guide Microprocessor and heat sink 10 Sata IDE connectors Fan connector 11 Clear CMOS/Recovery jumper Installing memory Installing PCI adapters What to do nextSecurity features Changing the battery Password protectionPadlock Erasing a lost or forgotten password clearing Cmos Replacing the cover and connecting the cables Viewing and changing settings Using the Setup UtilityStarting the Setup Utility program Using passwordsAdministrator or Supervisor Password Selecting a temporary startup device Exiting from the Setup Utility programSelecting a startup device Changing the startup device sequenceUser Guide Appendix A. Updating system programs Updating flashing Bios from a disketteSystem program User Guide Cleaning an optical mouse Appendix B. Cleaning the mouseCleaning a mouse with a ball User Guide Appendix C. Manual modem commands Basic AT commandsSet Tone Dial as default Low speaker volumeSet Pulse dial as default Internal speaker on until carrier detectedExtended AT commands MNP/V.42/V.42bis/V.44 commands Fax Class 1 commands Fax Class 2 commandsVoice commands Appendix C. Manual modem commands User Guide Appendix D. Notices Television output notice TrademarksIndex Page Page Part Number 41T3715