Lenovo 8011, 8814, 8810, 8801, 8793, 8805, 8797 Modem safety information, Laser compliance statement

Page 13

Dispose of the battery as required by local ordinances or regulations.

Modem safety information

Caution

To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.

To reduce the risk of fire, electrical shock, or injury when using telephone equipment, always follow basic safety precautions, such as:

vNever install telephone wiring during a lightning storm.

vNever install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

vNever touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

vUse caution when installing or modifying telephone lines.

vAvoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

vDo not use the telephone to report a gas leak in the vicinity of the leak.

Laser compliance statement

Some personal computer models are equipped from the factory with a CD-ROM drive or a DVD-ROM drive. CD-ROM drives and DVD-ROM drives are also sold separately as options. CD-ROM drives and DVD-ROM drives are laser products. These drives are certified in the U.S. to conform to the requirements of the Department of Health and Human Services 21 Code of Federal Regulations (DHHS 21 CFR) Subchapter J for Class 1 laser products. Elsewhere, these drives are certified to conform to the requirements of the International Electrotechnical Commission (IEC) 60825-1 and CENELEC EN 60825-1 for Class 1 laser products.

When a CD-ROM drive or a DVD-ROM drive is installed, note the following handling instructions.

Caution

Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.

Do not remove the drive covers. Removing the covers of the CD-ROM drive or DVD-ROM drive could result in exposure to hazardous laser radiation. There are no serviceable parts inside the CD-ROM drive or DVD-ROM drive.

Some CD-ROM drives and DVD-ROM drives contain an embedded Class 3A or Class 3B laser diode. Note the following statement.

Danger

Laser radiation when open. Do not stare into the beam, do not view directly with optical instruments, and avoid direct exposure to the beam.

Important safety information

xi

Image 13
Contents User Guide Types 8011, 8793, 8797 Types 8805, 8810 Page User Guide Types 8011, 8793, 8797 Types 8805, 8810 Page Contents Appendix B. Notices Conditions that require immediate action Important safety informationService General safety guidelinesPower cords and power adapters Plugs and outlets Extension cords and related devices Batteries Heat and product ventilation CD and DVD drive safetyLithium battery notice Additional safety informationLaser compliance statement Modem safety informationPower supply statement Introduction Xiv User Guide Comfort Arranging your workspaceGlare and lighting Electrical outlets and cable lengths Air circulationConnecting your computer Setting up your computerUser Guide Setting up your computer 1394 Setting up your computer Finishing the software installation Turning on powerCompleting important tasks Updating your operating system Installing other operating systemsUpdating your antivirus software Shutting down the computerUser Guide Features Installing optionsInternal drives Operating systems, preinstalled varies by model Available options Environment SpecificationsSupported operating positions Handling static-sensitive devices Tools requiredLocating connectors on the front of your computer Installing external optionsLocating connectors on the rear of your computer Obtaining device drivers Connector DescriptionOpening the cover Locating components Identifying parts on the system board Installing memory What to do next Installing PCI adaptersUser Guide Installing internal drives Drive specifications Installing a drive in bay Connecting drives Connecting additional serial ATA hard disk drive Installing a diskette drive in bay What to do next Identifying security locks Security featuresRope Clip Integrated cable lock Password protection Changing the battery Erasing a lost or forgotten password clearing Cmos Closing the cover and connecting the cables User Guide Creating and using product recovery discs Recovering softwareTo use Product Recovery discs, do the following Backup and recoveryUsing the Rescue and Recovery workspace Creating and using rescue media Solving recovery problemsTo create rescue media, do the following Creating and using a Recovery Repair disketteSetting a rescue device in the startup sequence Recovering or installing device driversRecovering software User Guide Starting the Setup Utility program Using the Setup UtilityViewing and changing settings Using passwordsAdministrator Password User PasswordSetting, changing, and deleting a password Selecting a startup deviceExiting from the Setup Utility program Advanced settingsChanging the startup device sequence User Guide Updating flashing Bios from a diskette Using system programsUpdating system programs User Guide Basic troubleshooting Troubleshooting and diagnosticsDiagnostic programs PC-Doctor for DOS PC-Doctor for WindowsRunning diagnostics from the CD or diskettes Cleaning the mouseNon-optical mouse Optical mouseUser Guide Information resources Getting information, help, and serviceOnline Books folder ThinkVantage Productivity CenterWarranty and safety Access HelpHelp and service Calling for service Using the documentation and diagnostic programsPurchasing additional services Using other servicesBasic AT commands Appendix A. Manual modem commandsLow speaker volume Enable RTS/CTS hardware flow control Extended AT commands+MS=? MNP/V.42/V.42bis/V.44 commandsFax Class 2 commands Fax Class 1 commandsVoice commands Appendix A. Manual modem commands User Guide Appendix B. Notices Trademarks Television output noticeIndex Page Page Part Number
Related manuals
Manual 98 pages 41.27 Kb