5.Remove the memory module being replaced by opening the retaining clips as shown.
6.Position the replacement memory module over the memory connector. Make sure the notch 1on the memory module aligns correctly with the connector key 2 on the system board. Push the memory module straight down into the connector until the retaining clips close.
7.Reinstall the PCI riser assembly and adapters.
8.Go to “Completing the CRU replacement” on page 28.
Replacing an adapter
Attention
Do not open your computer or attempt any repair before reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick Reference or the HMM, go to the Support Web site at http://www.lenovo.com/think/support.
To replace the adapter:
1.Open the computer cover. See “Opening the cover” on page 5.