Lenovo 57315603, 57315617, 57312695, C440, C445, C345, C540 manual Removing the foot cover

Page 37

4.To release the stand base from the stand holder, twist the hand screw ring counter-clockwise until the base comes loose.

5.Slide the stand base out from the holder then put it aside.

6. Refer to “Installing the computer stand” to reinstall the stand base.

Removing the foot cover

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.

Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches or other damage.

1.Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating system, and turn off the computer and all attached devices.

2.Unplug all power cords from electrical outlets.

3.Disconnect all cables attached to the computer. This includes power cords, input/output (I/O) cables, and any other cables that are connected to the computer. Refer to “Left and right views” and “Rear view” for help with locating the various connectors.

4.Remove the foot base. Refer to “Removing the foot base”.

32User Guide

Image 37
Contents Lenovo C3/C4/C5 Series Important Safety Information Page Contents Hardware Replacement Guide Using the Computer Hardware Front view of the computer Left and right views of the computer Rear view of the computer Installing the computer stand Computer stand Connecting your computer Connecting the power cord Important information about using the computer Connecting to the Internet Wired keyboard selected models onlyUsing Windows Switching between apps Switching between the main Windows 8 interfacesCharms Bar Shutting down the computerOpening other system programs Closing an appWindows Help and Support User Guide Using the Rescue System OneKey Recovery Method 1 Automatic Installation Driver and Application InstallationMethod 2 Manual Installation User Guide Troubleshooting Confirming Setup Troubleshooting Display Problems Solving ProblemsTroubleshooting Audio Problems Troubleshooting Software Problems Troubleshooting Problems with Optical Drives and Hard Disks Special considerations for troubleshooting Windows When do I need to change the boot mode? Bios setup utilityPerforming Daily Maintenance Tasks Hardware Replacement Guide Overview Safety information for replacing CRUsTools required Additional information resourcesHandling static-sensitive devices General information Replacing hardwareRemoving the stand base Removing the foot cover Replacing a memory module Replacing the hard disk drive User Guide Replacing the optical drive User Guide Replacing the adapter Connect the new adapter as shown To replace the keyboard Replacing the keyboard and mouseDeclaration AppendixTrademarks 10102/4773 10103/4751 10104/6595 10105/6596 10110/6267 Energy Star StatementEnabling ErP compliance mode