E n g l i s h
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, please call
Problem
No power.
No picture.
Completely distorted picture or black/ white picture.
The aspect ratio of the screen cannot be changed even though you have set the TV display.
No sound or distorted sound.
The DVD system does not work.
The disc tray cannot open and “TRAY LOCKED” is displayed.
Solution
–Check if the AC power cord is properly connected.
–Press the STANDBY ON on the front of the DVD system to turn on the power.
–Refer to your TV’s manual for correct Video In channel selection. Change the TV channel until you see the DVD screen. (see page 18)
–Press DISC on the remote.
–Switch the
–If this happens when you changing the setting of the ‘TV SYSTEM’, wait for 15 seconds for auto recovery. (see page 19)
–Check the video connection. (see pages
–Sometimes a small amount of picture distortion may appear. This is not a malfunction.
–Clean the disc. (see page 10)
–The aspect ratio is fixed on the DVD disc.
–Depending on the TV, it may not be possible to change the aspect ratio.
–Adjust the volume.
–Check the speaker connections and settings. (see pages 11, 20)
–Disconnect the headphones.
–Press the correct source button on the remote (TV or AUX, for example) to choose the equipment that you want to hear through the DVD system. (see pages 12, 13, 15)
–Disconnect the power cord from the power outlet for a few minutes. Reconnect the power cord and try to operate again as usual.
–Press and hold SOURCE button on the front panel for more than two seconds, then press PLAY button.
36