Setting up your monitor
This section provides information on how to set up your monitor.
Connecting and turning on your monitor
Note: Be sure to read the Safety Information located in the Monitor Safety, Troubleshooting, and Warranty Guide before carrying out this procedure.
1.Power off your computer and all attached devices, and unplug the computer power cord.
2.Connect the analog signal cable to the video port on the back of the computer. Note: One end of the signal cable is already
Place the cable into the specific hook indicated in below figure.
3.Connect the digital cable to the DVI connector of the monitor and the other end on the back of the computer.
Place the cable into the specific hook indicated in below figure.
4.Insert the power cord into the monitor ,then plug the monitor power cord and the computer cord into grounded electrical outlets.
Chapter 1.