Sanyo PLC-XL50 owner manual Logo Logo and Logo PIN code lock settings, Logo select, Capture

Logo (Logo and Logo PIN code lock settings)

This function allows you to customize the screen logo with Logo select, Capture, and Logo PIN code lock functions.

✔Note:

•When “On” is selected in Logo PIN code lock function, Logo select and Capture functions cannot be selected.

Logo select

This function decides the start-up display as follows: User………The image you captured

Default……The factory-set logo

Off…………Countdown only

Capture

This function enables you to capture the image being projected and use it for a start-up display or interval of presentations.

After capturing the projected image, go to the Logo select function and set it to “User.” Then the captured image is displayed when the projector is turned on next time or the NO SHOW button is pressed (p 26).

To capture the image, select “Yes.” To cancel the Capture function, select “No.”

✔Note:

•Before capturing an image, select "Standard" in the Image Select Menu to capture a proper image (pp.32- 33, 40-41).

•A signal from a computer can be captured up to XGA(1024x 768). A signal from video equipment can be captured except for 720p, 1035i, and 1080i. •When you capture the image that has been adjusted by the Keystone function, the adjusted data is automatically reset and the projector captures an image without keystone adjustment.

•When the Logo PIN code lock function is “On,” Capture menu cannot be selected.

•When you start to capture a new image, the previously stored image is cleared even if you cancel the capturing.

•User cannot be selected when the image is not captured.

Logo select

Capture

Select "Yes" to capture the projected image.

Select "Yes" to stop capturing.