Sanyo PLC-XP100L Remote control does, Not work, Wireless mouse, Function does not, Work

Appendix

Problem:		Try These Solutions
Remote control does		● Check the batteries.
not work..		● Check if the ALL-OFF switch on the remote control is set to “ON.”
		● Check if the RC sensor is set properly. (See page 51)
		● Make sure no obstruction is between the projector and the remote control.
		● Make sure you are not too far from the projector when using the remote control.
		Maximum operating range is 16.4’ (5 m).
		● Make sure that the remote control code conforms to the projector’s code.
		(See page 51.)
		● Unlock the Key lock function for the remote control. (See page 53).
		● Wireless remote control does not work when the remote control cable is connected to
		the projector. (See page 15).
Wireless mouse		● Check the cable connection between the projector and your computer.
function does not		● Check the mouse setting on your computer.
work..		● Turn on the projector before you turn on the computer.
Unable to unlock the		● Contact the service station.
Logo PIN code lock,
Security key lock or
Security PIN code
lock..
	on the	● Your operation is invalid. Operate correctly.
appears
screen

WARNING:

High voltages are used to operate this projector.. Do not attempt to open the cabinet..

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty, and electrical hazards.

The CE Mark is a Directive conformity mark of the European Community (EC).

Pixelworks ICs used.

65