Sanyo PLC-XW56 owner manual Lamp control, On start Remote control

Setting

On start

When this function is "On", the projector is automatically turned on just by connecting the AC power cord to a wall outlet.

9Note:

Be sure to turn the projector off properly (see "Turning Off the Projector" on page 19). If the projector is turned off in the incorrect sequence, the On start function does not operate properly.

Lamp control

This function allows you to change brightness of the screen.

Normal	normal brightness
Auto	brightness according with the
Eco . .	input signal
	lower brightness reduces the lamp
	power consumption and extends
	the lamp life.

Remote control

This projector provides two different remote control codes: the factory-set initial code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

When operating the projector in "Code 2", both the projector and the remote control must be switched to "Code 2".

To change the code for the projector:

Select either "Code 1" or "Code 2" in this Setting Menu.

To change the code for the remote control:

Press and hold both the MENU and IMAGE buttons together for 5 seconds or more. After changing the code, make sure the remote control operates properly.

9Note:

If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.

On start

Remote control

Press and hold MENU and IMAGE buttons for more than 5 seconds.

47