Sanyo PLC-ET30L owner manual Indicators and Projector Condition

Appendix

Indicators and Projector Condition

Check the indicators for the projector condition.

WARNING TEMP.. indicator

		Indicators
					Projector Condition
	POWER		LAMP	WARNING
				TEMP.
	green		red
				red
					The projector is off. (The AC power cord is unplugged.)
					The projector is in stand-by mode. Press the ON/STAND-BY button to
					turn on the projector.
					The projector is operating normally.
					The projector is in the Power management mode.
					The projector is preparing for stand-by or the projection lamp is
					being cooled down. The projector cannot be turned on until cooling is
					completed and the POWER indicator stops blinking.
					The WARNING TEMP. indicator blinks slow when the temperature
					inside the projector is elevated close to the abnormally high level.
					The temperature inside the projector is abnormally high. The
					projector cannot be turned on. When the projector is cooled down
					enough and the temperature returns to normal, the POWER indicator
					stops blinking and the projector can be turned on. (The WARNING
					TEMP. indicator keeps blinking.) Check and clean the filter.
					The projector has been cooled down enough and the temperature
					returns to normal. When turning on the projector, the WARNING
					TEMP. indicator stops blinking. Check and clean the filter.
POWER, LAMP, WARNING					The projector detects an abnormal condition and cannot be turned
					on. Unplug the AC power cord and plug it again to turn on the
TEMP., WARNING FILTER,
and LAMP REPLACE					projector. If the projector is turned off again, unplug the AC power
indicators are blinking all					cord and contact the dealer or the service center. Do not leave the
together.					projector on. It may cause an electric shock or a fire hazard.

• • • lighting • • • blinking • • • off

68