Hitachi CPX275W user manual Loading the Batteries, First Loading, Replacing, Remote Controller

BEFORE USE (continued)

Part Names (continued)

STANDBY/ON Button		STANDBY/ON	VIDEO	RGB
KEYSTONE Button		KEYSTONE
	Button
	Button		MENU
			SELECT
	Button
	Button	MENU	POSITION RESET
MENU Button
MAGNIFY	Button	MAGNIFY	FREEZE	VOLUME
MAGNIFY	Button
MAGNIFY OFF	Button			MUTE
		OFF
		AUTO		BLANK
AUTO Button

VIDEO Button

RGB Button

MENU SELECT Button

POSITION Button

RESET Button

VOLUME Button

VOLUME Button

FREEZE Button

MUTE Button

BLANK Button

Battery Holder	(Refer to Page.8 "OPERATIONS")
	Remote Controller

Loading the Batteries

First Loading:

In original packing, the battery is installed in the battery holder of
the remote controller with protection film(the transparent film some
of which is inside the battery folder). Pull out the protection film to	“+” side
load the battery.

Replacing:
1.	See the reverse side of the remote controller.
2.	Pinch the groove and pull out battery holder as the drawing right.	Pull out
3.	Remove the worn battery.
4.	Install the new battery with “+” side facing.	Battery Holder
5.	Push in and click the battery holder.

CAUTION • Incorrect handling of the battery could result in fire or personal injury.The battery may explode if not handled properly. Be careful in handling the battery

according to instructions of accompaning manual "SAFETY INSTRUCTIONS"and this manual.

•Use the 3V micro lithium battery type no.CR2025 only.

•When loading the battery, make sure the plus and minus terminals are correctly oriented as indicated in the remote controller.

•When you dispose the battery, you should obey the law in the relative area or country.

•Keep the battery away from children and pets.

•When not to be used for an extended period, remove the battery from the remote controller.

NOTE Replace the batteries when remote control transmitter operation becomes difficult.

ENGLISH-4