Hitachi CP-AW250N user manual Connection, Command Control via the Network

Page 11

1.

2.

Command Control via the Network

Command Control via the Network

When the projector connects network, the projector can be controlled with RS- 232C commands from the computer with web browser.

For details of RS-232C commands, refer to RS-232C Communication / Network command table (&17).

Connection

Turn off the projector and the computer.

Connect the projector's LAN port and the computer's LAN port with a LAN cable. Use the cable that fulfi lls the specifi cation shown in fi gure (Use CAT-5

or greater LAN Cable when LAN ports are used )

3. Turn the computer on, and after the computer has started up turn the projector on.

LAN cable (CAT-5 or greater)

		LAN				LAN

11

Image 11

Contents CP-AW250N Example of computer signalInitial set signals Computer IN1, B Computer IN2, C Monitor OUT Connection to the portsVideo CEC SCLSDA USB Type a To input component video signal to Computer in ports RS-232C Communication ConnectionCRC Communicaion settingsResponse code / Error code h shows hexadecimal Command Control via the Network Port1 Port Communicaion PortTCP #9715 Command format Command control settingsAutomatic Connection Break AuthenticationNetwork Bridge Communication Operating Guide Communication settingsRS-232C Communication / Network command table Gamma Gain B Color TempGain R Gain GTint Offset BColor Temp Offset B ColorExecute PhaseAuto Adjust SizeFrame Lock Hdmi RangeComputer IN1 Computer IN2Auto ECO PerfectMonitor OUT ECO ModeVolume MirrorType a Volume HdmiVolume LAN Volume USBLanguage MIC VolumeHdmi Audio MIC LevelMenu Position MenuPosition H Menu Position HDisplay Power onAuto Power TemplateMY BUTTON-2 MY BUTTON-1High MY SourceRemote Freq NormalAvmt ? PJLink commandLamp ?