Hitachi CP-AW250N user manual Communication settings, Operating Guide

Page 16

Network Bridge Communication (continued)

Communication settings

For communication setting, use the OPTION - SERVICE - COMMUNICATION menu. (&OPTION menu - SERVICE - COMMUNICATION in the User's Manual

- Operating Guide)

Item

Condition

BAUD RATE	4800bps / 9600bps / 19200bps / 38400bps
Data length	8 bit (fixed)
PARITY	NONE/ODD/EVEN
Start bit	1 bit (fixed)
Stop bit	1 bit (fixed)
Transmission method	HALF-DUPLEX/FULL-DUPLEX

NOTE • For connecting the projector to your devices, please read the manual for each devices, and connect them correctly with suitable cables.

•Turn off (the power of ) both the projector and other devices and unplug , beore connecting them.

•For details of Transmission method, refer to 6.4 Transmission method

-Network Guide.

16

Image 16

Contents Example of computer signal CP-AW250NInitial set signals Connection to the ports Computer IN1, B Computer IN2, C Monitor OUTVideo SDA SCLCEC USB Type a To input component video signal to Computer in ports Connection RS-232C CommunicationCommunicaion settings CRCResponse code / Error code h shows hexadecimal Command Control via the Network Communicaion Port Port1 PortCommand control settings TCP #9715 Command formatAuthentication Automatic Connection BreakNetwork Bridge Communication Communication settings Operating GuideRS-232C Communication / Network command table Gamma Color Temp Gain RGain G Gain BOffset B Color Temp Offset BColor TintPhase Auto AdjustSize ExecuteHdmi Range Computer IN1Computer IN2 Frame LockPerfect Auto ECOECO Mode VolumeMirror Monitor OUTVolume Hdmi Volume LANVolume USB Type aMIC Volume Hdmi AudioMIC Level LanguageMenu Position HMenu Position H Menu PositionPower on Auto PowerTemplate DisplayMY BUTTON-1 MY BUTTON-2MY Source Remote FreqNormal HighPJLink command Avmt ?Lamp ?