NEC LT75Z user manual Phase manually

[Page 3] (Advanced mode) [Page 4] (Advanced mode)

Setup

Page1	Page2	Page3	Page4
Auto Adjust		On	Off
Auto Start		On	Off
Power Management		On	Off
Power Off Confirmation		On	Off
Keystone Save		On	Off
White Segment		On	Off

[Auto Adjust]

When “Auto Adjust” is set to “On”, the projector automati- cally determines the best resolution for the current RGB input signal to project an image using NEC’s Advanced AccuBlend Intelligent Pixel Blending Technology.

The image can be automatically adjusted for geometry and stability; “Horizontal Position”, “Vertical Position”, “Clock” and “Phase”.

On	Automatically adjusts image “Horizontal Position”,
	“Vertical Position”, “Clock” and “Phase”.
Off	User can adjust the image display functions (“Hori-
	zontal Position”, “Vertical Position”, “Clock” and
	“Phase”) manually.

[Auto Start]

Turns the projector on automatically when the power cable is inserted into an active power outlet and the main power switch is on. This eliminates the need to always use the “Power” button on the remote control or projector cabinet.

[Power Management]

When this option is on and there is no RGB input for five minutes or more, the projector will automatically turn itself off.

NOTE: This feature does not work with Video or S-Video sources.

[Power Off Confirmation]

This option determines whether a confirmation dialog for turning off the projector will appear or not.

[Keystone Save]

This option enables you to save your current keystone set- tings. Saving your change once affects all sources. The changes are saved when the projector is off.

[White Segment]

You can put emphasis on either brightness or color for a projected image.

If you prefer putting emphasis on brightness, place a checkmark in the box to turn the option on. If you prefer an image in truer color, turn off this option.

Setup

Page1	Page2	Page3	Page4
Default Source Select			Select
Default Source			RGB
Communication Speed			19200bps
Control Panel Key Lock			Unlocked
Clear Lamp Hour Meter

[Default Source Select]

You can set the projector to default to any one of its inputs each time the projector is turned on.

Last	Sets the projector to default to the previous or last
	active input each time the projector is turned on.
Auto	Searches for an active source in order of RGB →
	Video → S-Video and displays the first found source.
Select	Displays the selected source input every time the
	projector is started up. Select an input from the pull-
	down menu.

[Communication Speed]

This feature sets the baud rate of the PC Control port (Mini DIN 8 Pin).

it supports data rates from 4800 to 19200 bps.

The default is 19200 bps. Select the appropriate baud rate for your equipment to be connected.

E-32