NEC LT150/LT85 user manual Terminal Panel Features

Terminal Panel Features

1

PO

WER

US

2

ON/

STAND

BY

3

SOURCE

4

A

PC

U

D

IO

CARD

AUTO

ADJUST

R

ACCESS

G

5

B

S-

V

ID

E

P

O

C C

O

6

N

T

L

R

O

V

ID

E

O

U

S

P

B

C C

7

A

R

D

8

AC

IN

E N

T E R

MENU

SELECT

CANCE L

1. Audio Input Mini Jack (3.5 mm ∅)

This is where you connect audio output from your computer, VCR, DVD player or laser disc player.

A commercially available audio cable is required.

2.RGB Input/ Component Input Connector (Mini D-Sub 15 pin)

Connect your PC or other RGB equipment such as IBM or com- patible computers. Use the supplied RGB cable to connect to a PC. Or connect a Macintosh computer here using the supplied RGB cable. This also serves as a component input connector that allows you to connect a component video output of component equip- ment such as a DVD player.

9

10

cluded in the supplied CD-ROM must be installed on your PC. If you are writing your own program, typical PC control codes are on page E-59.

A cap is put on the port at the factory. Remove the cap when using the port.

3. S-Video Input (Mini DIN 4 Pin)

Here is where you connect the S-Video input from an external source like a VCR.

NOTE: S-Video provides more vivid color and higher resolution than the traditional composite video format.

4.Video Input (RCA)

Connect a VCR, DVD player, laser disc player, or document cam- era here to project video.

5.PC Card Eject Button

Press to eject a CompactFlash memory card.

6. PC Card Slot

Insert a CompactFlash memory card here.

7. PC Control Port (Mini DIN 8 Pin)

Use this port to connect your PC to control your projector via a serial cable. This enables you to use your PC and serial communi- cation protocol to control the projector. The NEC optional serial cable is required to use this port. Also PC Control Utility 1.0 in-

8. USB Terminal

Connect a commercially available mouse that supports USB. You can operate the menu or PC Card Viewer with the USB mouse via this terminal.

Note that this terminal is not used with a computer and that there may be some brands of USB mouse that the projector does not support.

9 AC Input

Connect the supplied power cable's three-pin plug here. When you plug the other end into an active wall outlet, the POWER indicator turns orange and the projector is in standby mode.

10 Built-in Security Slot ( )

This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington Microware Inc.

The logo is trademarked and owned by Kensington Microware Inc.

E–11