NEC 1800 manual Cut Here Second Fold Here, Accessing the Printer Controller Board, Introduction

Cut Here	Second Fold Here		Cut Here
			Cut Here
		Accessing the Printer Controller Board (continued)
		6.	Gently pull tab to release side-panel (C).
		7.	Slide side-panel towards back (D).
SuperScript 1800
Instructions for the		C	D
Apple LocalTalk and Serial Interface Upgrade Kit

Introduction

Installation involves accessing the Printer Controller Board then installing the interface card.

Tools Required

Phillips-head Screwdriver

Accessing the Printer Controller Board		8.	Rotate side-panel away from the printer (assure wire-
1.	Turn off the printer.		snaps on the parallel port are not in the way), then lift
			away (E).
2.	Pull-out the Tray 2 (A).	9.
			Loosen top screw of controller board cover, remove
3.	Disconnect all cables from printer.
			remaining four screws, then remove cover by lifting up
4.	Position the printer so the right-side can	be accessed.
			then towards you.(F).
5.	Remove screws from side-panel, then open back panel (B).
A	B	E	F

	Cut Here
Cut Here	Second Fold Here	Cut Here