JBL Century Gold manual Maintenance and Service

Page 14

Maintenance and Service

The Century Gold loudspeaker systems have an oiled finish. Cleaning should be done with an untreated dust cloth. Do not use conventional furniture waxes and polishes, which are not designed for oiled finishes. If touch-up is necessary or the finish appears to be drying out, the surface may be re-oiled with a commercially available oil-finishing preparation. Do not use any solvents on the finish.

The grille may be gently vacuumed. Stains may be removed with an aerosol cleaner, following its instructions. Do not use any solvents on the grille.

All wiring connections should be inspected and cleaned or remade periodically. The frequency of maintenance depends on the metals involved in the connections, atmospheric conditions, and other factors, but once per year is the minimum. The battery should be replaced approximately every three years. Consult your JBL dealer for specific recommendations.

If a problem occurs, make sure that all connections are properly made and clean. If a problem exists in one loudspeaker, reverse the speaker wires to the left and right system. If the problem remains in the same speaker, then the fault is with the loudspeaker. If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your Century Gold loudspeaker system ever needs service, contact your

local JBL dealer.

No.

12

Image 14
Contents N t u r y G o l d Genuine JBL Page Page Low-Frequency Transducer Matched spider To motor for high linearityMid-Frequency Transducer High-Frequency TransducerDividing Networks Battery Replacement Battery Replacement RecordPlacement PlacementSpeaker Connections Standard Connections FigureFrequency-optimized Cables Bi-WiringReduction of Intermodulation Amplifier FlexibilityBi-Wiring Connections Preamp w/Y-corded output Stereo ampsBi-Amp Connecting Method Bi-Amping ConnectionsMaintenance and Service System Specifications Table of Contents