Bi-Wiring Connections

Figures 8 through 10 show two bi-wiring options, single stereo ampliﬁer and dual stereo ampliﬁer modes. For passive and bi-wire connections, set the switch to the Normal/Bi-Wire position (Figure 8a).

Important

1.The external “strapping bars” that normally connect the Century Gold’s low-frequency and high-frequency terminals must be removed before bi-wiring. To remove the shorting straps, simply loosen and slide the bars off to the side (Figure 11).

2.Never connect two ampliﬁers to the same loudspeaker without ﬁrst removing the strapping bars. Operating two ampliﬁer channels without removing the strapping bars can seriously damage your ampliﬁers!

3.If you have hooked up your Century Gold loudspeakers in any of the bi-wire conﬁgurations indicated, it is not advisable to use additional speakers separately or simultaneously.

4.As with conventional one-ampliﬁer connections, make sure that all speaker cables are the same length.

Figure 8 Bi-Wire Connecting Method

AMP

NORMAL/

BI-WIRE

JBL INCORPORATED 8500 BALBOA BLVD. NORTHRIDGE, CA USA

HIGH FREQUENCY

LOW FREQUENCY

Figure 8a Normal/Bi-Wire Position

Bi-AMP

NORMAL/

BI-WIRE

Figure 9 One-Amp Bi-Wire

	Preamp
HF	HF
LF	LF

Stereo amp

No.

Figure 10 Two-Amp Bi-Wire

Preamp w/Y-corded output

HF	HF
LF	LF

Stereo amps

Figure 11 Removal of Shorting Straps

AMP

NORMAL/

BI-WIRE

JBL INCORPORATED 8500 BALBOA BLVD. NORTHRIDGE, CA USA

HIGH FREQUENCY

LOW FREQUENCY