EPSON PowerLite Home 10 Projector
Cleaning the Air Filter
If the air filter becomes clogged with dust, it can cause overheating and damage the projector. Follow these steps to clean the filter:
1.Press the P Power button to turn the projector off, and wait for the P power light to stop flashing.
2.Unplug the power cord and disconnect any cables.
3.Turn the projector
4.Use a small vacuum cleaner designed for computers and other office equipment to clean the air filter. If you don’t have one, gently clean the filter using a very soft brush (such as an artist’s
Note: If the air filter is difficult to clean or if it is broken, it should be replaced. See the next section for instructions.
3.Turn the projector
4.Replace the air filter with a new one. Make sure there are no gaps between the air filter and the plastic grill.
5.To replace the cover, insert the tabs and press down until the cover clicks into place.
Replacing the Lamp
The projection lamp typically lasts for about 2000 hours of use. (If you use Theatre Black color mode almost exclusively, the lamp lasts about 3000 hours.) It is time to replace the lamp when:
Replacing the Air Filter
If you need to replace the air filter, you can call EPSON at
(800)
(800)
Follow these steps to replace the air filter:
1.Press the P Power button to turn the projector off, and wait for the P power light to stop flashing.
2.Unplug the power cord and disconnect any cables.
❏The projected image gets darker or starts to deteriorate.
❏The 
warning light on top of the projector flashes red at
❏The message Replace the lamp appears on the screen when you start projecting. To maintain projector brightness and image quality, replace the lamp as soon as possible after you see the message.
Request replacement lamp part number V13H010L2H.
Note: To view the number of hours your lamp has been used, check the Info menu.
Warning: Be very careful when removing the lamp. Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury. In the unlikely event that the bulb has ruptured, small glass fragments may be present and should be removed with caution. If your projector is mounted on the ceiling, you should unmount it. This will make it easier for you to replace the lamp and minimize the chance of any small glass fragments dropping from the projector.
10 - EPSON PowerLite Home 10 Projector | 7/03 |