EPSON PowerLite Home 10 Projector
Turning the Projector On and Off
Once you’ve connected the projector to your computer or other equipment, follow these instructions to turn it on and display an image:
1.Make sure the power is turned off for the projector and any sources connected to it.
2.Remove the lens cover.
3.Connect one end of the power cord to the projector and plug the other end into a grounded electrical outlet.
The P Power light on the projector turns orange, indicating that the projector is receiving power, but is not yet turned on.
Orange
Note: The projector will not respond to any buttons on the control panel or remote control while the power light is flashing orange.
4.If you are connecting to video equipment, turn it on now. (If you are connecting to a computer, don’t turn it on yet.)
5.Press the P Power button on the remote control or the top of the projector to turn on the projector.
You hear a beep, the P Power light flashes green as the projector warms up, and the projection lamp comes on in about 45 seconds.
6.If you are using a computer, turn it on now.
The projector automatically detects the video source and begins projecting.
If you don’t see a picture, make sure the P power light on the projector is green and not flashing, and the lens cover is off. Also, make sure your cable is connected to both the projector and your video equipment, and the video equipment is on. If you still don’t see a picture, see the suggestions in the Troubleshooting section on page 6.
Turning Off the Projector
When you’re ready to shut down the projector, follow these steps:
1.Turn off your video equipment first. (If you’re connecting to a computer, leave the computer on.)
2.Press the P Power button on the projector or remote control.
3.When you see the confirmation message, press the P Power button again to turn the projector off. (If you don’t want to turn it off, press any other button or ignore the message. It disappears in about 7 seconds.)
The lamp is turned off and the P Power light flashes orange as the projector cools down. When the projector has cooled, the P Power light stays orange and the exhaust fan shuts off.
Note: If you want to turn the projector on again, wait until the orange light stops flashing. Then press the P Power button.
4.Unplug the power cord from the electrical outlet.
Caution: Never disconnect the power cord while the
P power light is green or flashing orange. You may damage the projector.
5.Replace the lens cover and retract the projector’s adjustable feet.
6.Store the remote control in its holder on the back of the projector. (Part of the remote control will stick out when it’s fully inserted.)
Adjusting the Image
1. To raise the picture, turn the projector’s front feet.
4 - EPSON PowerLite Home 10 Projector | 7/03 |