Philips LX3750W warranty Other Functions, Tuning to radio stations, Presetting radio stations

Other Functions

Tuning to radio stations

1Press STANDBY ON to switch on the last selected source.

2Press SOURCE (or press TUNER) to select TUNER mode.

3Press TUNER again to select the desired band : FM or AM.

4Press and hold S or T until the frequency indication starts to change, then release.

➜ The system automatically tunes to the next strong radio station.

Note:

–If “PROGRAM” icon goes off before you select the desired preset number, press PROGRAM again.

4Press PROGRAM again to store the radio station. ➜ “PROGRAM” icon stops flashing.

●Repeat steps 1–4to store other radio stations.

Notes:

–The old stored content in the selected address will be covered when you operates the unit as above.

–During programming, if no key is pressed within five seconds, the system will exit the program mode automatically.

E n g l i s h

FM 103.50 SUB

●To tune to a weak station, press S or T briefly and repeatedly until an optimal reception found.

5Repeat step 4 if necessary until you find the desired radio station.

Presetting radio stations

You can preset up to 40 stations regardless of the reception.

1Tune to your desired radio station (refer to “Tuning to radio stations”).

2Press PROGRAM.

➜ “PROGRAM” appears.

P00 103.50 SUB

PROGRAM

3Use the numeric keypad (0-9)to select the desired preset number.

P01 103.50 SUB

PROGRAM

Listening to preset radio stations

●In tuner mode, press 1 or 2 or use the numeric keypad (0-9)to select the desired preset number.

➜ The preset number, radio frequency, and waveband are displayed.

Sleep timer setting

The sleep timer enables the system to switch to standby mode automatically at a preset time.

1Press SLEEP repeatedly to select a preset time.

➜The selections are as follows (time in minutes):

15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120™ OFF ™ 15...

SLEEP	45	MIN
			SUB

2When you reach the desired length of time, stop pressing the SLEEP button.

➜ “SLEEP” icon appears.

To check the remaining length of time after sleep timer is activated

●Press SLEEP once.

To change the preset sleep timer

●Press SLEEP again while the remaining sleep timer is shown.

➜ The display will show the next sleep timer options.

To deactivate the sleep timer

●Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.

OTHER FUNCTIONS 27