Epson R210 manual Fourth step Set up the Continuous Ink Supply System, Fiveth step Fix Support Arm

Page 4

Circumgyrate screwdreiver	Separate the right side of	Take off the cover of cartridge-car
deasilly	cartridge-car

4)Fourth step: Set up the Continuous Ink Supply System

Remove original cartridge	Insert our no-sponge cartridge	Close the cover for cartridge
	into printer carefully

5) Fiveth step: Fix Support Arm

Tear off the sticker	Fix the arm on the 25cm right far from Tear off the sticker
	you printer

Fix the balance arm	Tear off the sticker of clamp	Attached the clamp on your printer
		and let it parallel with printer

Image 4

Contents For ST Prefilled Version With Auto Reset Chips 、Printer testing 、General Guide、Installation Procedures Third step Set up the Continuous Ink Supply SystemFirst step ）Second step Remove cartridgeFourth step Set up the Continuous Ink Supply System Fiveth step Fix Support ArmSixth step Install tubeline Seventh Step Adjust the tubeline、Refill Ink 、Reset Procedure9Nineth step Nozzle check How to install the cover of cartridge 、Attention for maintenance