Changing the volume level
You can change the speakers’ sound distribution to suit your surround sound needs.
●Press CENTER +/- to adjust the level of the centre speaker.
➜“CNT +XX DB” is displayed.
●Press REAR +/- to adjust the level of the rear surround speakers.
➜“RE +XX DB” is displayed.
Note:
– “XX” denotes the volume level between
Setting up the subwoofer
1Use the supplied subwoofer cable to connect the subwoofer’s audio input jack to the WOOFER LINE OUT of the DVD system.
2Connect the subwoofer’s AC power cable to the wall
socket and switch on the power.
➜ It will automatically switch on when receiving an audio signal input. If there is no audio signal input, it will switch off automatically.
3Select the phase polarity at the rear of the subwoofer at either 0o or 180o to determine better bass reproduction effect in certain listening environment.
4Press SUBW +/- to adjust the volume level of the
subwoofer
➜ “SUB +XX DB” is displayed.
Activating progressive scan
mode (for model LX3500D only)
The
To enjoy the full quality potential offered by progressive scan feature, a progressive scan TV is required.
1Press STANDBY ON to switch the system off.
2Slip the
3Press STANDBY ON again to switch the system on.
Note:
– You need to switch the system off before changing the progressive scan mode.
System Setup (DVD)
The system setup is carried out via the TV, it enabling you to customise the DVD system to suit your particular requirement. If the preferred options selected are not available on a disc, then the disc’s own preference will be used.
IMPORTANT !
To access the System Setup menu, playback must be stopped.
General operation
1Press SYSTEM MENU.
➜ icon will be highlighted in the menu bar on the TV screen.
2Press 4 to activate the System Setup menu.
3Use 1 2 34 keys to toggle through the functions and select your preferred option.
4Press OK to confirm a highlighted selection.
5To exit the System Setup menu, press SYSTEM MENU or OK.
The following items are available :
Setting the picture 
– TV Shape
Select the aspect ratio of the TV to be connected.
4:3 PS (default setting)
–If you have a conventional TV set and your DVD is not formatted for widescreen viewing, use this setting. A wide picture is displayed on the whole TV screen with a portion automatically cut off.
4:3 LB
–If you have a conventional TV set and your DVD is formatted for widescreen viewing, use this setting. Wide bands will be displayed on the upper and lower portions of the TV screen.
16:9
–If you have a widescreen TV set, use this setting (you must also set your widescreen TV to “full size”).
English
PREPARATIONS 15
pg | 15 | 4/16/02, 11:21 AM |