3.3 Mounting
This card is intended to be mounted in a Tellabs Type 10 or equivalent open frame rack. To avert erroneous operation, don’t install the card adjacent to equipment that generates high temperature or electromagnetic radiation. Al- ways provide an appropriate service loop on in- terconnecting cables.
3.4 Access for Installation/Servicing
When installing into a Tellabs Type 10 or equivalent open frame rack, ensure the front and rear of the rack have clear access for card installation and wiring.
To service, remove the 1505 from the rack or place on a circuit card extension for access while troubleshooting.
3.5 Power
Primary power for the card is a regulated source of 12 Vdc.
Figure 1. 1505 Component Location
2