Philips GFP451-1825BX-1 Before using the remote control, Speakers Connection Front Speakers

Page 10

Preparations

English

CSpeakers Connection

Front Speakers

Connect the speaker wires to the SPEAKERS terminals, right speaker to "R" and left speaker to "L", coloured (marked) wire to "+" and black (unmarked) wire to "-".

Fully insert the stripped portion of the speaker wire into the terminal as shown.

Notes:

For optimal sound performance, use the supplied speakers.

Do not connect more than one speaker to any one pair of +/- speaker terminals.

Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

Before using the remote control

1Pull out the plastic protective sheet.

2Select the source you wish to control by pressing one of the source select keys on the remote control (for example CD, FM).

3Then select the desired function (for example

É, í, ë).

Replacing battery (lithium CR2025) into the remote control

1Push to open the battery tray.

2Replace a new battery according to the indicated polarity.

3Push the battery tray back to close it.

CAUTION!

Remove battery if they are exhausted or will not be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

10

Image 10
Contents Micro Hi-Fi System MCM177Mains plug How to connect a plugImportant notes for users in the U.K Copyright in the U.KPage Page Index Contents General Information Supplied accessoriesSafety Information Environmental InformationTo establish a safe volume level Hearing SafetyListen at a moderate volume Set your volume control at a low settingRear connections PowerPreparations Antenna Connection FM AntennaSpeakers Connection Front Speakers Before using the remote controlReplacing battery lithium CR2025 into the remote control Pull out the plastic protective sheetControls on the remote control Controls on the systemNumeric Keypad Basic Functions To reinstall Plug and PlayFirst time setup/power up To exit without storing the Plug and PlaySwitching the system on Adjusting volume and soundPower-saving automatic standby Basic playback controls CD/MP3 OperationLoading a disc Playing an MP3/WMA discReviewing the programme Different play modes Shuffle and RepeatProgramming track numbers Erasing the programmeRadio Reception Tuning to radio stationsTuning to preset radio stations Programming radio stationsSupported formats Using USB connectivityUSB Connection System will not play or support the followingUsing AUX in 2 white/red jacks Using AUX in 3.5 mm jackListening to an external source Setting the timer Clock/TimerSetting the clock Viewing clockCleaning the Cabinet SpecificationsMaintenance Cleaning DiscsTroubleshooting Check the speaker connections and locationTroubleshooting Meet Philips at the Internet