Installing the FireWire | A |
cable | FireWire connectivity. |
| 1. Plug the end of the cable with the right angle into the scanner. |
2.Connect the other end of the cable into the 1394a card outlet in the host computer. Be sure that it is installed correctly and properly seated.
CAUTION: DO NOT FORCE THE CONNECTOR. If the cable is not properly connected, it could cause damage to the scanner.
Attaching the power cord The Kodak i1860 Scanner is packed with a set of power cords.
1.Select the power cord which complies with your electrical requirements and attach it.
2.Turn on the main power switch on the back of the scanner.
3.Turn on the scanner and wait until the operator control panel touchscreen indicates that the scanner has completed the
Powering up the system 1. Turn the power on to the host computer.
NOTE: The first time the host computer communicates with the scanner, Windows will request an STI driver through the “Add New Hardware” function. Follow the prompts to load the Windows STI driver.
2.Connect the scanner.
3.Power up the scanner.
11 |