NEC LCD71V manual Removing the Base, Connecting a Flexible Arm, Replace screws, Specifications

Quick Start –continued

Removing the Base

Note: Always remove the Base when shipping the LCD.

1. Place monitor face down on a non-abrasive surface (Figure R.1).

2. While using your thumbs, press the bottom tabs upward to unlock.

3. Press the top tabs down to unlock and pull off the stand.

Connecting a Flexible Arm

This LCD monitor is designed for use with a flexible arm. Please use the attached screws (4pcs) as shown in the picture when installing.

To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. GS mark).

Replace screws

Thickness of Bracket (Arm) 2.0~3.2 mm

Tighten all screws.

75 mm (LCD51V)

100 mm (LCD71V)

Specifications

75 mm (LCD51V)

100 mm (LCD71V)

4-SCREWS (M4) (MAX depth: 8.5 mm)

If using other screws, check depth of holes.

Weight of LCD assembly: 2.6 kg - LCD51V (MAX) 4.0 kg -LCD71V (MAX)

6

AS5171Vmanual073003.p65 6 7/3/03, 3:15 PM