NEC LCD72V, LCD52V manual Monitor AccuSync LCD92V Specifications, 1280 x 960*1 at 75 Hz

Specifications –continued

Monitor		AccuSync LCD92V	Notes
Specifications		Monitor
LCD Module	Diagonal:	19.0 inch	Active matrix; thin film transistor (TFT)
	Viewable Image Size:	19.0 inch	liquid crystal display (LCD); 0.294 mm dot
Native Resolution (Pixel Count):		1280 x 1024	pitch; 250cd/m2 white luminence;
			450:1 contrast ratio, typical
Input Signal	Video:	ANALOG 0.7 Vp-p/75 Ohms
	Sync:	Separate sync TTL Level (Positive/Negative)
		Horizontal sync Positive/Negative
		Vertical sync Positive/Negative
Display Colors	Analog input:	16,194,277	Depending on display card used.
Maximum	Left/right:	65°/65° (CR>10)
Viewing Angles	Up/Down:	65°/65° (CR>10)
Synchronization	Horizontal:	31.5 kHz to 81.1 kHz	Automatically
Range	Vertical:	55 Hz to 76 Hz	Automatically
Resolutions Supported		720 x 400*1 : VGA text	Some systems may not support
		640 x 480*1 at 60 Hz to 75 Hz	all modes listed.
		800 x 600*1 at 56 Hz to 75 Hz
		832 x 624*1 at 75 Hz
		1024 x 768*1 at 60 Hz to 75 Hz
		1152 x 864*1 at 70 Hz
		1152 x 870*1 at 75 Hz	NEC-Mitsubishi Electronics Display cites
		1280 x 960*1 at 75 Hz	recommended resolution at 60 Hz for
		1280 x 1024 at 60 Hz to 75 Hz................ optimal display performance.
Active Display Area	Horizontal :	376 mm/14.8 inches
	Vertical :	301 mm/11.9 inches
Power Supply		100-240 V ~ 50/60 Hz
Current Rating		0.8 - 0.5A/100-240V
Dimensions		418 mm (W) x 427.8 mm (H) x 199.5 mm (D)
		16.5 inches (W) x 16.8 inches (H) x 7.9 inches (D)
Weight		6.5 kg
		14.3 lbs
Environmental Considerations
Operating Temperature:		5°C to 35°C/41°F to 95°F
	Humidity:	30% to 80%
	Feet:	0 to 10,000 Feet
	Storage Temperature:	-10°C to +60°C/14°F to 140°F
	Humidity:	10% to 85%
	Feet:	0 to 40,000 Feet

*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.

NOTE: Technical specifications are subject to change without notice.

14

AS52V72V92VManual080404.p65 14 8/5/04, 7:46 PM