NEC LCD193WM, LCD223WM, LCD203WM user manual Contents, Quick Start

Contents

Your new NEC AccuSync LCD monitor box* should contain the following:

¥AccuSync LCD monitor with tilt base

¥Audio Cable

¥Power Cord

¥Video Signal Cable

¥UserÕs Manual

¥CD-ROM

¥Base Stand

¥ Cable Holder

Cable Holder CD-ROM

English

UserÕs Manual Audio Cable	Power Cord	Video Signal Cable	Base Stand	AccuSync LCD monitor
				(base stand not connected)

*Remember to save your original box and packing material to transport or ship the monitor.

Quick Start

To attach the Base to the LCD Stand:

1.Attach the Base to the Stand. The locking tabs on the Stand should fit into the hole on the centre back of the Base (Figure S.1).

To attach the Cable Holder:

1. Insert the tabs of Cable Holder into the hole of Stand and slide the Cable Holder downward into place (Figure S.1).

NOTE: Please confirm that the tabs are completely secure.

Stand

	Locking Tabs
Cable Holder	Base
		Macintosh Cable
Figure S.1	Figure A.1	Adapter (not included)	Figure A.2

To attach the AccuSync LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync Macintosh cable adapter (not included) to the computer. Attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure A.2). Tighten all screws.

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

English-3