NEC Specifications for LCD1970NXp, Monitor Specifications MultiSync LCD1970NXp Monitor

Specifications for LCD1970NXp

Monitor Specifications		MultiSync LCD1970NXp Monitor	Notes
LCD Module	Diagonal:	48.2 cm/19.0 inches	Active matrix; thin film transistor (TFT)
Viewable Image Size:		48.2 cm/19.0 inches	liquid crystal display (LCD); 0.294 mm dot
Native Resolution (Pixel Count):		1280 x 1024	pitch; 250 cd/m2 white luminance;
			800:1 contrast ratio, typical.
Input Signal	Video:	ANALOG 0.7 Vp-p/75 Ohms	Digital Input: DVI
	Sync:	Separate sync.TTL Level
		Horizontal sync. Positive/Negative
		Vertical sync. Positive/Negative
		Composite sync. Positive/Negative*2
		Sync on Green (Video 0.7 Vp-p and Sync. 0.3 Vp-p)*2
Display Colours		16,777,216	Depends on display card used.
Synchronization Range	Horizontal:	31.5 kHz to 81.1 kHz (Analog)	Automatically
		31.5 kHz to 81.1 kHz (Digital)	Automatically
	Vertical:	56.0 Hz to 75.0 Hz	Automatically
Viewing Angle	Left/Right:	88°/88° (CR > 10)
	Up/Down:	88°/88° (CR > 10)
Resolutions Supported		720 x 400*1 : VGA-Text	Some systems may not support all modes
		640 x 480*1 at 60 Hz to 75 Hz	listed.
		800 x 600*1 at 56 Hz to 75 Hz
		832 x 624*1 at 75 Hz
		1024 x 768*1 at 60 Hz to 75 Hz
		1152 x 870*1 at 75 Hz
		1280 x 1024 at 60 Hz to 75 Hz....................NEC DISPLAY SOLUTIONS cites
			recommended resolution at 60 Hz for
			optimal display performance.
Active Display Area	Horizontal:	376.3 mm/14.8 inches
	Vertical:	301.1 mm/11.9 inches
Power Supply		AC 100-240V ~ 50/60Hz
Power Consumption		38W (typ)
(without optional Sound Bar)
Current Rating		1.2-0.6A
Dimensions		412.5 mm (W) x 386.5-496.5 mm (H) x 220.0 mm (D)
		16.2 inches (W) x 15.2-19.5 inches (H) x 8.7 inches (D)
Weight	Net:	8.0 kg (17.7 lbs)
	Gross:	10.3 kg (22.7 lbs)
Environmental Considerations
Operating Temperature:		5°C to 35°C/41°F to 95°F
	Humidity:	30% to 80%
	Feet:	0 to 10,000 Feet
Storage Temperature:		-10°C to 60°C/14°F to 140°F
	Humidity:	10% to 85%
	Feet:	0 to 30,000 Feet

*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.

*2 If your display is not showing a picture of the SOG and Composite Sync. Signal, please contact our hotline for further assistance.

NOTE: Technical specifications are subject to change without notice.

English-14