NEC LCD1701 For the Customer to use in U.S.A. or Canada, Declaration of Conformity, English-2

Page 3

For the Customer to use in U.S.A. or Canada

Canadian Department of Communications Compliance Statement

DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouiller du Canada.

C-UL:Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CSA C22.2 No. 60950.

Ce produit porte la marque ‘C-UL’ et se conforme aux règlements de sûrele Canadiens selon CAN/CSA C22.2 No. 60950.

FCC Information

1.Use the attached specified cables with the LCD1701 colour monitor so as not to interfere with radio and television reception.

(1)The power supply cord you use must have been approved by and comply with the safety standards of U.S.A., and meet the following condition.

Power supply cord Length

Plug shape

Non shield type, 3-conductor 2.0 m

U.S.A

(2)Shielded video signal cable. Use of other cables and adapters may cause interference with radio and television reception.

2.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult your dealer or an experienced radio/TV technician for help.

If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions. The user may find the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.

Declaration of Conformity

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

U.S. Responsible Party:

NEC-Mitsubishi Electronics Display of America, Inc.

Address:

1250 N. Arlington Heights Road

 

Itasca, Illinois 60143-1248

Tel. No.:

(630) 467-3000

 

 

Type of Product:

Display Monitor

Equipment Classification:

Class B Peripheral

Model:

LCD1701

We hereby declare that the equipment specified above conforms

to the technical standards as specified in the FCC Rules.

English-2

Image 3
Contents LCD1701 Declaration Declaration of the ManufacturerEnglish-1 FCC Information For the Customer to use in U.S.A. or CanadaDeclaration of Conformity Canadian Department of Communications Compliance StatementQuick Start ContentsEnglish-4 Figure C.1Tilt and Swivel Remove Monitor Stand for MountingEnglish-5 English-6 SpecificationsBrightness/Contrast Controls Auto AdjustControls OSM On-Screen-Manager ControlsTools Colour Control SystemsOSM Warning Factory PresetDisplay Mode InformationSafety Precautions and Maintenance Recommended useEnglish-10 English-11 SpecificationsMonitor Specifications LCD1701 L172EN Monitor ErgonomicsEnglish-12 FeaturesTroubleshooting TCO’99