NEC LCD1990FXp user manual Quick Start, English-4

Quick Start

To attach the LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws.

For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure B.1). Tighten all screws.

Figure A.1 Figure A.2

Macintosh

Cable Adapter Figure B.1 (not included)

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

3.With one hand, grip the top of the display by the handle using the other hand to grip the bottom and tilt the LCD panel 30-degree angle and lift up to the highest position (Figure C.1).

4.Connect all cables to the appropriate connectors (Figure C.1).

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the moduleÕs life.

5.To keep the cables neatly organized, place them into the cable management system that is built into the stand. Place the power cable into the specific hooks as indicated (Figure C.2).

Place the DVI cable and the 15-pin mini D-Sub signal cable into the hooks as indicated (Figure C.2).

When using the monitor in Portrait mode, place the DVI cable and the 15-pin mini D-Sub signal cable into the hooks as indicated (Figure C.3).

6.Make sure all cables are resting flat against the stand (Figure C.2).

Please check Tilt, Rise and Lower monitor screen and screen rotation when you manage cables.

30û Tilt

Highest

Stand

Position

DC-OUT NEC optional product attachment.

Do not use this connector unless specified.

DVI-I

D-SUB

Power cord

Figure C.1

English-4