Quick Start, Sub | NEC RDF225WG manual

Quick Start

To attach the monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.If necessary, install the display card into your system. For more information, refer to the display card manual.

3.For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D- SUB end of the signal cable to the Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the Macintosh cable adapter, call NEC-Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.

4.Connect the other end of the signal cable to the connector on the back of the monitor.

5.Connect one end of the power cord to the monitor and the other end to the power outlet (Figure C.1).

6.Turn on the monitor (Figure D.1) and the computer.

NOTE: The Windows¨ 98/2000/Me/XP INF file download from http://www.nmv.co.jp/

NOTE: If you have any problems, please refer to the Troubleshooting section of this UserÕs Manual.

Figure A.1

Figure B.1

15-pin

mini

D-SUB

Mac Adapter

(Not Included)

Video Signal Cable

RDF225WGmanual051804.p65

5/18/04, 10:03 AM