NEC LCD1530V user manual Quick Start, English-6

Quick Start

To attach the MultiSync LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync LCD1530V Macintosh cable adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB end of the appropriate signal cable to the MultiSync LCD1530V Macintosh cable adapter (Figure B.1). Tighten all screws.

Remove connector cover and cable cover on back of monitor (Figure E.1).

3.Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on the back of the monitor (Figure C.1).

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the module’s life.

4.Connect one end of the power cord to the MultiSync LCD Series monitor and the other end to the power outlet. Place the video signal cable and AC power cord under the clips. (Figure C.1).

Replace connector cover and cable cover. (Figure E.1)

NOTE: Adjust the position of the cable under the clips to avoid damage for cable or monitor.

5.Turn on the monitor (Figure D.1) and the computer.

6.To complete the setup of your MultiSync LCD monitor, use the following OSM controls:

•Auto Adjust Contrast

•Auto Adjust

Refer to the Controls section of this User’s Manual for a full description of these OSM controls.

NOTE: If you have any problems,please refer to the Troubleshooting section of this User’s Manual.

NOTE: For easy removal of the cable cover or signal cable, place the monitor face down. (Figure R.2)

English-6