Quick Start –continued
Remove Tilt/Swivel Base
To remove the tilt/swivel base from the AccuSync monitor, follow these instruction:
1.With the monitor unplugged from your system and the wall outlet, carefully turn the monitor upside down on a firm table (Figure TS.1).
2.Push down on the latch of the tilt/swivel base and slide the tilt/swivel base backward from the front of the monitor (Figure TS.5).
3.Pull out the tilt/swivel base from the six holes on the bottom of the monitor (Figure TS.6).
front of monitor
Figure TS.5 | Figure TS.6 |
4
AS507090.wpc | 6 | 5/14/01, 11:22 AM |