Contents
Your new NEC AccuSync LCD monitor box* should contain the following:
•AccuSync LCD monitor with tilt base
•Power Cord
•Video Signal Cable
•Setup Manual
•Base Stand
•Cable Holder
|
|
| Cable Holder |
|
Setup |
|
|
|
|
Manual |
|
|
|
|
Setup Manual | Power Cord*1 | Video Signal Cable | Base Stand | AccuSync LCD monitor |
|
|
|
| (base stand not connected) |
*Remember to save your original box and packing material to transport or ship the monitor.
*1 Type of power cord included will depend on the where the LCD monitor is to be shipped.
Quick Start
English
To attach the Base Stand to the LCD Stand:
1. Attach the Base Stand to the Stand. The locking tabs on the Base Stand should fit into the hole on the Stand (Figure S.1).
To attach the AccuSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the
For the MAC: Connect the Macintosh cable adapter (not included) to the computer and then attach the
NOTE: Some Macintosh systems do not require a Macintosh cable adapter. | Figure S.1 | ||
|
|
|
|
|
|
|
|
Stand
Base Stand
DVI Signal Cable (not included) |
|
Figure A.1 | Figure A.2 |
Macintosh Cable Adapter | Figure A.3 |
(not included) |