Lexmark 3300 manual Series All-In-One, Steps, Safety information

See the troubleshooting guide on the reverse of this sheet. *23A0170*

3300 Series All-In-One www.lexmark.com

Unpack your All-In-One.

1 Note: Contents may vary based on geography.

Note: You may need to purchase a USB cable separately.

Your All-In-One may include a	Connect the power cord to the power supply.
photo cartridge instead of a	2
black print cartridge.

Before you continue, remove the photo cartridge from the print cartridge storage unit.

2

1

Note: Save the print cartridge storage unit to protect any open cartridges not in use.

3

Make sure the power light is on.

4	Press	to scroll to your language		5	Lift the paper support and extend
	and then press		.		the paper exit tray.

6	1	Pull back the transparent deflector.	Lift the scanner unit.
	2	Load the paper flat and to the right.	7

3Squeeze the paper guide. Slide it to the right until it is snug.

2

3

1

Remove the sticker and tape 8 from the print cartridges.

1 2

1 2

9

Left: photo or black

1Open the cartridge lids by pressing the front tabs.

2Insert the cartridges and push them down firmly.

3Snap the lids tight.

Right: color only

1 2 3

10

Close the scanner unit.

2

1

3

11	Press	to print
	an alignment page.

Safety information

CAUTION: Do not set up this product or make any electrical or cabling connections, such as the power supply cord or telephone, during a lightning storm.

•Use only the power supply provided with this product or the manufacturer's authorized replacement power supply.

•Connect the power supply cord to an electrical outlet that is near the product and easily accessible.

•Refer service or repairs, other than those described in the user documentation, to a professional service person.

You may discard the page after it prints.

Steps 12–15