4090-001
3. Diagnostic Aids
Use these diagnostic test procedures to verify a repair. There are two ways to enter test procedures, each procedure will indicate the method to use:
Procedure 1:
•Press and hold the Paper Feed button while turning the printer on. Release the button when the printer completes POST.
Procedure 2:
•
•
Turn the printer off.
Use a two pin jumper on connector J6 as indicated, then turn the printer on. The test begins when the power button is pressed.
Note: You can use the two pin jumper on J7 to perform the tests. Remember to return the jumper to J7 when the test is finished.
A two pin jumper is also available in the parts packet: 1367169 and 69G4188.
Diagnostic Aids