Emerson LXP48F1 manual Ambient Loop Recm 90C, Current Operating Length Ft, Crimp Lug Amps, List GA

SAG582135000						System Application Guide
Issue AE, January 31, 2007				Spec. No. 582135000 (Model LXP48F1)
									Home
	Maximum	Ambient	Loop	Loop	Recm 90°C		Recommended
	Current	Operating	Length (Ft)	Length (Ft)
					Wire Size	(1)	Crimp Lug	(3)
	(Amps)	Temperature (1)	1.0 Volt Drop (2)	0.25 Volt Drop (2)
			List BB, BD, BL, BS, LB, LD, LS, LX
	500	40°C	37	9	(3) 4 AWG		(3) 245346800
			59	14	(3) 2 AWG		(3) 245350800
	500	50°C	37	9	(3) 4 AWG		(3) 245346800
			59	14	(3) 2 AWG		(3) 245350800
	400	65°C	59	14	(3) 2 AWG		(3) 245350800
			List GA
	163	40°C	36	9	(1) 2 AWG		(1) 245350800
	155	50°C	38	9	(1) 2 AWG		(1) 245350800
	110	65°C	54	13	(1) 2 AWG		(1) 245350800

Table 5

Recommended Battery Wire Size and Lug Selection

Notes to Tables 5:

1Wire sizes are based on recommendations of the American National Standards Institute (ANSI) approved National Fire Protection Association's (NFPA) National Electrical Code (NEC). Table 310-17(Single-Insulated Copper Conductors in Free Air) for wire rated at 90°C conductor temperature operating in ambient temperatures of 40°C, 50°C and 65°C was used. For other operating ambient temperatures, refer to the NEC. For operation in countries where the NEC is not recognized, follow applicable codes.

2Recommended wire sizes are sufficient to restrict voltage drop to the voltage shown in the column heading, or less, at rated full load output current of the shelf for the loop lengths shown in this column. Loop length is the sum of the lengths of the positive and negative leads.

3Two-hole lug, 1/4" bolt clearance hole, 5/8" centers. Refer to drawing 031110100 for lug crimping information.

DC Input Wire Sizes and Lugs—List GA

Features

♦In the List GA Distribution Cabinet, lug-terminated battery conductors are connected to the battery terminals. Captive nuts, (1/4-20 on 5/8" centers) are provided for installation of customer provided two-hole lugs.

♦For lug mounting hole size and spacing dimensions, refer to the illustration provided in the Physical Size Information section.

Restrictions

All lugs for customer connections must be ordered separately. Customer must supply lug-mounting hardware.

Ordering Notes

1)Refer to Table 5 for recommended wire sizes and lugs at rated maximum Distribution Cabinet load. When making connections, observe correct polarity.

2)For other available lugs and hardware, refer to drawings 031110100 through 031110300.

Page 26 of 43

This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy

Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.