Primera Technology Optical Disc Printing System user manual Maintenance, Cleaning the Printer

Page 40

TOC

INDEX

Section 6: Maintenance and

Troubleshooting

The Printer is designed to operate for extended periods of time with very little attention. In fact, no regular maintenance is recommended other than cleaning the outside case.

NOTE: Do NOT attempt to oil or grease the Printer's Robotic Arm shaft or other components. You will likely cause more harm than good! Any moving parts are designed to operate for the life of the machine with no additional lubrication required.

A. CLEANING THE PRINTER

Use a clean, lint-free rag with a small amount of ammonia window cleaner to clean the Printer's outside case and trays. This type of cleaner is very effective on inks that may accumulate on the printer tray. Stronger cleaning solutions are NOT recommended because they may damage the paint and plastic materials from which the parts are manufactured. Always disconnect your Printer's power cords before cleaning. Resume operation only after the surfaces are completely dry.

B. PERFORMING A ROBOTIC SELF-TEST

To ensure that everything is working properly, a Self-Test feature is built in to your Printer. In this mode, the Robotic Disc Transporter will go through the motions of picking and placing a disc to ensure proper working order. This test may be performed without connecting the Printer to the PC.

Perform the test by doing the following steps:

•Load some discs into the Input Bin

•Open the top recorder tray by pressing the eject button on the recorder.

•Make sure the Printer's front cover is closed

•With the Printer turned on, press the Cartridge Button

•While holding the Cartridge Button, press the Power

Button until the robotics start to move.

36Maintenance and Troubleshooting

Page 39 Page 41
Image 40
Page 39 Page 41
Contents For Macintosh and PC Printing History Table of Contents Interactive Feature in this Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts Front Panel and TopRear Panel PC System RequirementsMAC System Requirements Overview of OperationIndex Hardware and Software Setup Installing the PC SoftwareInstalling the MAC Software Set-UpApplying Power Hardware SetupLoading Media Discs Index Connecting the USB 2.0 Cable Select Install the software automatically and click NextInstalling Ink Cartridges Do not Touch the Copper AreaTutorial Printing Discs on a PC Index Index Setting UP the Printer Driver Printing Discs on a PCPaper Size Resolution Non-printable Outer MarginDisc Surface Quality Cartridge TypeInk Saturation Calibration OptionsInner Diameter Inner Diameter Non-Printed DiameterCenter The Print Image BackEnable Ink Low Warning Clean/Change Cartridges & Check Ink LevelsChange Cartridges Clean/PurgeDetails Using Surething Disc Output LocationIndex Index Using Other Graphics Programs Using Kiosk ModePrinting Discs on a Mac Printed Label Format RequirementsPrinting Printer OptionsPrint Settings Kiosk Mode Configuration Utility Outer MarginClean Cartridge Alignment Calibration Print Change CartridgeImage Alignment Tough lines whose Index Interpreting the Printers Indicator Lights LEDCleaning the Printer MaintenancePerforming a Robotic SELF-TEST Clearing a Media JAM Cleaning the INK CartridgesTransporting the Printer Technical Support Technical Specifications DVD-R, DVD RAM, DVD+R, DVD+RIndex Page Page
Top Page Image Contents